Humminbird ICE Flasher Series User Manual

1
532506-3_A
ICE FISHING TRANSDUCER Installation Guide
Use the instructions in this guide to install the ICE transducer.
Installation Preparation
Read the instructions in this transducer guide completely to understand the mounting guidelines
before starting the installation.
NOTE: The procedures and features described in this guide are subject to change without notice.
This guide was written in English and may have been translated to another language. Humminbird
is not responsible for incorrect translations or discrepancies between documents.
NOTE: The illustrations in this guide may not look the same as your product, but your unit will
function in the same way.
WARNING! Always make sure that conditions are safe before walking on the ice.
Install the control head before you start the transducer installation. See the control head
installation guide.
Visit our Web site at humminbird.com for additional information and resources. Also, visit youtube.
com/humminbirdtv for informational videos.
Installation Overview
1
|
Test the Transducer Prior to Installation
WARNING! Always make sure that conditions are safe before walking on the ice.
NOTE: The control head ports are keyed to prevent reversed installation, so be careful not to force
the connectors into the wrong ports.
1. Connect the power cable to the control head and the battery terminal adapter. See your control
head installation guide for instructions.
2. Connect the transducer cable to the control head. See Connecting the Transducer Cable.
3. Lower the transducer into the ice hole.
4. Power On: Press the POWER key. While the Title screen is shown on the display, press the MENU
key. Select Normal mode, and press the RIGHT Cursor key to start Normal mode.
If you have an ICE™ Flasher Series control head, turn the Power/Range dial to A (Auto) or x1 to
power on the control head. If all connections are correct and power is available, the Humminbird
control head will enter Normal operation.
5. If the transducer is working properly, you will see the bottom on the sonar view.
6. Power Off: Press and hold the POWER key.
If you have an ICE Flasher Series control head, turn the Power/Range dial to Off.
7. Remove the transducer from the ice hole.
8. Disconnect Cables: Disconnect the transducer and power cable from the control head.
Disconnect the power cable terminals from the battery until installation is completed and
you're ready to fish.
2
|
Assembling the Transducer and Float
Follow these instructions to assemble the transducer and float.

Humminbird ICE Flasher Series Specifications

General

Brand	Humminbird
Model	ICE Flasher Series
Category	Transducer
Language	English

Summary

Installation Preparation

Ice Safety Warning

Always ensure conditions are safe before walking on ice for installation procedures.

Installation Overview

Test Transducer Before Installation

Connect and power the control head to test transducer function before final mounting.

Assemble Transducer and Float

Attach the float to the transducer cable and position it for submersion below the ice.

Connect Transducer Cable

Route and connect the transducer cable to the appropriate port on the control head unit.

Setting Up Ice Fishing on the Control Head

Configure ICE Series Control Head

Instructions for setting up ICE Series and ICE HELIX CHIRP Series control heads for ice fishing.

Configure ICE Flasher Series Control Head

Instructions for setting up ICE Flasher Series control heads for ice fishing mode.

Configure Non-ICE Series Control Head

Instructions for configuring non-ICE Series or non-ICE Flasher control heads for ice fishing.

Storing the Transducer

Portable Bag Storage Procedures

Guidelines for storing the transducer and cable in the portable bag after fishing.

Maintenance and Important Notices

Transducer Maintenance

How to clean and care for the transducer, especially after prolonged submersion.

Important Product Notices

Information on warranty, product changes, environmental compliance, and WEEE directive.