Your new Hunter thermostat will provide years of reliable service. Using this
digital thermostat will provide more uniform comfort in your home through the
seasons. Thank you for buying a Hunter product!
Please read this manual for complete instructions on installing and operating your
thermostat. If you require further assistance, call Hunter Technical Support at
1-888-830-1326 from 8am to 5pm Central Time.
This thermostat is designed to work on the following systems:
* Gas - Standing Pilot
* Gas - Electronic Ignition
* Gas - Fired Boilers
* Gas - Milivolt Systems
* Oil - Fired Boilers
* Oil - Fired Furnace
* Electric Furnace
* Electric Air Conditioning
This thermostat will NOT control single-stage or multi-stage heat pumps or
110/220 V baseboard electric heating systems.
This thermostat includes two #8 slotted screws and two wall anchors for mounting.
To install your thermostat, you should have the following tools and materials.
* Slotted Screwdriver(s)
* Small Philips screwdriver
* Hammer
* Electric drill and 3/16” bit
* Two 1.5 V (AA) size alkaline
batteries
To Next Page
Loading...
