Hunter Ananova - Installing the Canopy; Securing the Canopy; Installing the Fan Blades; Attaching Blades to Arms

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy
Screw
NOTICE
If screw holes do not align
properly then rotate the canopy
180 degrees. Hanger ball shape
must match canopy opening for
correct canopy installation.
Let the tool do the work!
A magnetic screwdriver will
give you more visibility when
securing the canopy.
Hunter Pro Tip:
x10
Lightly attach the blade arms to the motor with
the blade arm screws, then securely tighten
after both screws are attached.
Repeat x5
Blade Arm Screw
Remember the screws that you
kept after removing the shipping
blocks? You need them here.
D
I
S
C
A
R
D
K
E
E
P
!
Fan style may vary.
Note:
Installing the Blades:
x15
x15
Insert grommets found in the hardware bag into the
holes in the blades, then secure each blade to a blade arm
with screws found in the hardware bag.
Repeat x5
bag
bag
Blade Screw
Grommet
Fan style may vary.
Note:
IMPORTANT
NOTE: Follow the instructions on the blade. Installing
it incorrectly could result in your fan not functioning.
Remove instructional label after installation.
Assembling the Light
Installing the Bulb and Glass