16
contatobrasil@hunterfan.com
MD500-01 • 05/21/14 • © Hunter Fan Company
Lift the light kit up, tucking the wires into
the hole in the switch housing. Install the
center stem of the light kit into the lower
switch housing by turning the threaded rod
clockwise into the threaded hole. Continue
turning until tight.
Lift the lower switch housing until its screw
holes are aligned with the screw holes in the
upper switch housing. Install the three switch
housing screws, found in the hardware
bag. Tighten all three screws.
Light Kit Option (continued)
Threaded
Rod
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
To Next Page
Loading...
