9
Keyhole
Slot
Installing the Light Fixture
3 of 3
Light Kit
Assembly Screw
bag
Partially install light kit assembly screws,
found in the hardware bag, into the posts
as shown, leaving the circled post empty.
Light Kit Assembly
Screw
Empty Post
Connect the plugs from the upper
and lower switch housings. Make
sure to line up the colored markings
on the connectors and that the
connectors latch.
Align the three keyhole slots in the light
kit hood with the three assembly screws
in the posts. Lift the light kit assembly
and twist counterclockwise to lock it
into place.
Install a bulb into the
socket. When necessary,
replace with bulbs of
the same wattage.
Install the saved light kit
screw and tighten all four
screws securely.
This is the screw you saved that
was attached to the red ag.
Light Kit Screw
1 of 1
IMPORTANT
Make sure the light kit assembly is securely
attached to the light kit hood. Failure to properly
secure all four screws could result in the light kit
falling.
Installing the Glass and Light Fixture Cage
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Cage Remote Cradle
FAN FALL HAZARD
Make sure to secure the light xture.
To Next Page
Loading...
