Hunter e36 - Page 8

Hunter e36 • Operator's Manual
G
10. Sanitary Systems 10.1
10.1 Drains and Discharges 10.2
10.2 Pumps 10.3
10.3 Other Waste Related 10.4
10.4 Head System 10.5
10.5 Operations and Maintenance 10.5
10.6 Toilets 10.6
Troubleshooting 10.8
Black Water System 10.9
Sump Pump (Grey Water) System 10.11
Bilge Water (Grey Water) Layout 10.13
11. Engines and Transmissions 11.1
11.1 Engines 11.2
11.2 Transmissions 11.4
11.3 Operations and Maintenance 11.4
Troubleshooting 11.6
Engine Exhaust System 11.9
12. Sails and Rigging 12.1
12.1 Main Rig Components 12.2
12.2 The Mast 12.2
12.3 The Boom 12.2
12.4 The Sails 12.3
12.5 Reefing Instructions 12.3
12.6 Reefing Procedure 12.3
12.7 Shaking Out a Reef 12.3
12.8 Spinnaker (Option) 12.3
12.9 The Arch 12.4
12.10 B&R Rig 12.4
12.11 Tuning the B&R Rig 12.4
12.12 Protecting your Rigging 12.6
Sailplans & Sail Specification 12.7
Standing Rigging Detail (Layout) 12.8
Furling Standing Rigging Detail (Layout) 12.9
Upper Spreader Tip Detail 12.10
Lower Spreader Tip Detail 12.11
Standing Rigging Details (Specification)12.12
Conventional Standing Rigging 12.13
Furling Standing Rigging 12.14
Mainsheet Purchase 12.15
Boom to Mainsail Reefing 12.16
Standard Vang Detail 12.17
Optional Rigid Vang Detail 12.18
Running Rigging Layouts 12.19
Running Rigging Specification 12.20
Jib Furling Line Layout 12.21
Bridle Configuration 12.22
Lazyjack Installation 12.23
Optional Spinnaker Layout 12.25
13. Getting Underway 13.1
13.1 Boarding your Boat 13.2
13.2 Starting the Engine 13.3
13.3 Getting Underway 13.4
13.4 Returning to Port 13.6
13.5 Emergency Operations 13.6
14. Maintenance 14.1
14.1 Maintenance Materials 14.2
14.2 Exterior 14.2
14.3 Interior 14.5
14.4 Mechanical Systems 14.6
14.5 Periodic Maintenance 14.7
14.6 Storage and Lifting 14.8
14.7 Fitting out after Storage 14.10
Routine Maintenance 14.12
Exterior Lifting Points - Stern Drive 14.15
15. Glossary 15.1