Hunter e36 - Page 88

Hunter e36 • Underwater Gear
6.6
Fig 6.9 shows you a profile view of the anchoring, and
windlass system. This illustration shows the smaller and
the larger anchor well, in relation to the location.
W A R N I N G
! !
Anchoring in unusual water, and or weather condi-
tions will require additional precautions. Consult an
approved guide for suggestions.
6.5 Troubleshooting
Though we cannot cover every problem you might
encounter in boating, we hope to assist you in the
basic operation and maintenance of the com-
ponents aboard, or installed on your boat.
As difficult as it would be to also cover every option
or component installed we hope we have covered the
basic essentials you will need in order to have many a
safe and comfortable outings in your new boat. As in all
cases always consult your OEM manuals in all cases of
review of the documentation of the components aboard
or installed on your boat. If the manuals are not available
in your owner’s packet, contact Hunter Marine, or your
dealer. It is the ultimate in importance that you under-
stand all you should about the equipment on your boat.
Here we give you a short guide concerning the trouble-
shooting of the equipment that fall in the underwater
gear section of your boat. Read this guide, and use it in
trying to discover the root of any issues that might arise.
Remember: OEM manuals take precedence over any
information you may find in the Hunter Owner’s or
Operator’s Manuals.
ELEVATION
WELL: SMALLER MODELS
WATERLINE
WELL: LARGER MODELS
STAINLESS BOW ROLLER
Fig. 6.8
Fig. 6.9
PLAN
PLOW ANCHOR
DANFORTH
ANCHOR
ANCHOR RODE
(CHAIN OR ROPE OR COMBO)
TYPICAL CLEAT
LOCATIONS VARY
W/MODEL.
STAINLESS BOW ROLLER
(SIZE & SHAPE VARIES
BETWEEN MODELS)
NOTE: THE FORWARD "U" BOLT IN THE ANCHORWELL IS CONSIDERED THE
STRONG POINT. THAT SHOULD BE USED IF THE VESSEL IS TO BE TOWED
NOTE: ALWAYS SECURE ANCHOR RODE TO THE CLEAT OR
LASH ANCHOR SECURE TO BOW ROLLER IN ADDITION TO
THE QUICK PIN.