41343-01 7/1/2002
TROUBLESHOOTING
Nothing happens; fan does not move.
Noisy operation.
1. Power turned off, fuse blown, or
circuit breaker tripped.
2. Loose wire connections or wrong
connections.
3. Motor reversing switch not en-
gaged.
4. Pull chain switch not “on.”
5. Shipping bumpers still in place.
PROBLEM PROBABLE CAUSE SOLUTION
1. Turn power on, replace fuse, or
reset breaker.
2a. Loosen canopy, check all connections
according to STEP 4 - WIRING THE FAN
(turn power off before checking).
2b.Check the plug connection in the
switch housing according to STEP
7-ATTACHING THE SWITCH
HOUSING.
3. Push switch firmly up or down.
4. Pull switch chain.
5. Remove shipping bumpers.
continued
1. Tighten screws until snug.
2. Tighten screws until snug.
3. Replace all blades.
1. Blade brackets screwed loosely to
motor.
2. Blade screwed loosely to blade iron.
3. Blade cracked.
To Next Page
Loading...
