HCC - Quick Start Guide
HCC - Connecting AC Power
Connecting the controller to primary AC power should be done by a licensed electrician following all
local codes. Install in approved conduit and fittings. The controller can operate with either 120VAC
or 230VAC power. Supply wires must be 14AWG/ 2 mm
2
or larger.
IMPORTANT: If you are using the plug-in method, the wiring is exactly the same but you will require
an outlet. The plug referred to as a Pigtail (three wires including neutral, hot, and ground) can be
purchased at most hardware outlets or a Hunter Authorized Dealer [1] (P/N: PIGTAIL).
To Next Page
Loading...
