Product Overview
4
hydrawise.com
Step 3: Navigating WAND with X2
Locate the following:
A. Wi-FI status LED
B. Wi-Fi setup button
C. WAND serial number
The serial number is used to enable
Hydrawise management for the WAND.
You will be prompted to enter the serial
number during the online setup process
when adding the controller to your
Hydrawise account.
Leave the WAND module installed with the
dial in the RUN position during setup to
remain connected to Hydrawise soware.
If the WAND is removed, the controller
will revert to the programs and settings
congured via the dial and buttons.
To ensure the X2 controller operates with
Hydrawise, you must have the dial in
the Run position. The controller will not
operate remotely if the dial is in any other
position.
To Next Page
Loading...
