8
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs Remote CradleRemote
Partially install two light kit assembly
screws, found in the hardware
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
2 of 5
Light Kit Screw
bag
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the
included bulbs
into the sockets.
When necessary,
replace with
bulbs of same
wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Insert the third screw,
found in the hardware
bag, into place and then
tighten all three screws.
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole slots
around the screws and twist
counterclockwise.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the plugs from the upper and lower switch
housings. Make sure to line up the colored
markings on the connectors.
Lift and align the keyhole slots in the
light kit housing with the two screws.
Make sure all the wires from the fan
and the light kit are snug inside the
center of the light kit, not pinched in
between the upper switch housing and
the light kit or hanging out of the sides.
Turn the light kit counterclockwise until the
switch housing screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
1 of 5
Light Kit Screw
bag
2 of 5
Light Kit Screw
bag
Fan style may vary.
Note:
Fan style may vary.
Note:
Preparing the Light Fixture
This is a screw you saved that
was attached to the red ag.
Light Kit Screw
To Next Page
Loading...
