Hunter L451 - 2.3. Raising the Lift

When using a workstep, always ensure the workstep is fully engaged and locked into the cutout in the side of the runway.
Always use two hands to install the workstep as follows:
• Align the workstep hanger brackets with the cutouts in side of li rack.
• Push the workstep forward and down unl the locks “snap” into place.
Note the photos below:
See Image Yellow Decal Not Visible
Correct Installaon, Fully Inserted - The workstep hanger brackets have been fully inserted through the cross-cutout and
are locked in place.
See Image Yellow Decal Visible
Improper Installaon, Parally Inserted - The workstep is only parally through the cutouts. The yellow decal indicates
the workstep is not locked onto the side of the runway. In this unsafe condion, the step can easily be pulled out of the
runway. Push step forward and down unl locked.
Check the stability of the workstep by pushing down on the stepping surface before standing on it.
When using the workstep, always use a safe, sturdy, OSHA-approved two-rung stepladder, as intermediate steps to mount
the workstep.
To remove workstep, simultaneously pull back tabs to disengage locks.
CAUTION
D
o not use a workstep that is improperly installed. If the yellow decal indicates the workstep is not locked, the
step can pull out. Resulng injuries from falling are possible.
CAUTION
I
f using more than one portable workstep on one side of the li do not aempt to step across or jump from
one step to another. Serious injury could result from improper usage of the worksteps.
2.3. Raising the Lift
L45x 4 post lis have consoles mounted to the front le post. There are no controls on the pump housing. Check the li
and immediate area for obstrucons and remove any that are found. Verify that the turnplates and runway slip plates are
locked in place.
WARNING
D
o NOT operate li with jacks in use. Serious injury may result if the li is raised or lowered with a vehicle
supported by jacks.
Depress and hold the “RAISE” buon. The pump will begin to operate, raising the li. Release the “RAISE” buon when the
li reaches the desired height. The pump will shut o and the li will stop.
4-Post Lift Rack Models L451 & 454 Operations Manual
Page 17 of 28