Hunter L451 - 2.5. Unlock and Lock Slip Plates with PowerSlide Slip Plates (Optional)

NOTE
On lis with PowerSlide, the slip plates automacally lock as the li is lowered to the oor.
Depress and hold the “RAISE” buon unl the li rises o the locks (approximately 1 inch [25 mm]). Depress and hold the
“LOCK RELEASE” buon to disengage the locks.
While c
onnuing to hold the “LOCK RELEASE” buon, depress the “LOWER” buon unl the li reaches the desired
height.
Release both buons when the li r
eaches the desired height. Depress and hold the “lower” buon unl the mechanical
locks engage. If the li is being lowered completely, ensure the li rack is resng fully on the oor before removing the
wheel chocks. Remove all wheel chocks. Before removing vehicle from lowered li, verify that the turnplates and runway
slip plates are locked in place. Use lock pins if oponal PowerSlide feature is not present. Carefully drive the vehicle o the
runways.
2.5. Unlock and Lock Slip Plates with PowerSlide Slip Plates
(Optional)
Controls for the PowerSlide® slip plates are located either near li controls (-PS models) or on the FIA console (-IS models).
4-Post Lift Rack Models L451 & 454 Operations Manual
Page 19 of 28