Hunter Original - Installing Ceiling Hardware; Securing the U-Bracket

5
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Operation Troubleshooting
Hanging the Fan Wiring the Fan
Back out the set screw on the hanger bracket. Feed the wires through the
hanger bracket assembly and screw the hanger bracket onto the hanger
pipe until tight (at least 3 turns). Use pliers to tighten both the hanger
bracket assembly and the hanger pipe together.
Tighten the set screw in the motor housing and the hanger bracket assembly
NOTE: Some of the pipe threads may still be visible.
Be sure that the pin is centered in the rubber bushing. Lift the fan by the motor housing. Hook the hanger bracket assembly onto
the rubber bushing and pin. Ensure both ends of the pin are outside the
hanger bracket assembly
5
7
6
8
STEPSTEP STEPSTEP
IMPORTANT
TO SECURELY HANG THE FAN, CAREFULLY FOLLOW THE STEPS ON PAGES 7 AND 8. BE SURE TO TIGHTEN THE HANGER PIPE INTO
THE FAN AND THE HANGER BRACKET ONTO THE PIPE. TIGHTEN THE 2 SET SCREWS, AS DESCRIBED IN STEP 7, TO PREVENT THE
FAN FROM FALLING. YOUR FAN MAY WEIGH UP TO 50 LBS. ALL OF THE FOLLOWING STEPS MUST BE FOLLOWED IN ORDER TO
ENSURE A SECURE MOUNTING.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT
hand tighten setscrew.
WARNING
Never lift the motor by the wires.
Let motor rest in the carton liner
for protection.
Hanger Bracket
Hanger Bracket
Set Screw
Rubber
Bushing & Pin
Hanger Bracket
Assembly
Motor Housing
Set Screw
Hanger Pipe
Pin
Rubber
Bushing