Hunter Fan Company 41532-01 • 04/13/18
10
NOTE: Your canopy comes pre-assembled. Uninstall the canopy screws using a #1 Phillips-head
screwdriver and separate the two halves of the canopy before continuing to step 1.
1. Assemble canopy halves around pipe, and loosely install the canopy assembly screws.
2. Slide canopy up close to ceiling.
3. Tighten the canopy assembly screws (see Fig. 10) using a #2 Phillips-head screwdriver.
4. Tighten the canopy set screw (see Fig. 10) using a #1 Phillips-head screwdriver.
Installing The Canopy
Fig. 10
Canopy
Canopy Set Screw
Canopy Assembly
Screw
To Next Page
Loading...
