Hunter Orion - Menu Settings; Cam Settings

Menu
Slide the “Power Switch” to SETUP position and press “MENU” once to
enter camera setting menu. Navigate the setting interface by pressing
“◄”, “▲”, “►”, or “▼”, press “OK” for selection or “MENU” to exit to
previous page.
Note!
● For some settings, user needs to press “MENU” to save & exit the
configuration after pressing “OK” to confirm (Cam ID, Delay, Time Lapse,
Timer, Password).
● In other settings pressing “MENU” switches alpha/ digits/ symbols.
Cam
Settings
Programmable Options
Cam ID
Select “ON”, press “OK” to set 12 digits/ alphabets for each
camera. Such function can help user to identify photos are
from were and which camera.
Cam Mode
Photo – camera shoots photos only, based on configured
Multi-shot & Image Size.
Video – camera shoots videos only, based on configured
Video Length/Size.
PIC+Video – camera shoots photo(s) first, then video upon
same trigger event, based on configured Multi-Shot, Image
Size and Video Length/Size.
Flash LED
High – Stronger flash in dark environment. (consume more
battery current)
Low – Weaker flash in dark environment. (consume less
battery current)
Image Size
24 MP (5632*4224), 12 MP (4032*3024), 8 MP (3264*2448)
Night Mode
Min.Blur – Short exposure time to minimize motion blur for
better image quality; shortened IR flash range.
Max.Range – Longer exposure time to extend IR flash range
for better night vision; lower image quality.
Balanced – Combination of above 2 options.
Multi-Shot
Programmable 1~5 photos per trigger.
Video Size
FHD-1080P (1920*1080), HD-720P (1280*720), WVGA
(848*480)
Video Length
05~59 sec.