Hunter Orion - PIR Settings

PIR
Settings
Programmable Options
PIR Switch
ON – camera can take photos/ videos per motion even when
Time Lapse is ON.
OFF – camera will not be able to take photo/ video per
motion.
Sensitivity
High/ Middle/ Low
Higher sensitivity is a) more sensitive to movements by
smaller subjects; b) longer detection distance; c) easier for
sensor to detect difference between body heat and outdoor
temperature; d) easier to trigger camera to record.
In high temperature environment, body heat of subjects and
environment temperature is hard to tell by camera, suggest
setting High.
Delay
Select “ON”, press “OK”, to set a time interval between photos
or videos upon motion. This option can avoid camera taking
too many photos or videos.
Example: Camera will wait 5 minutes between photo/video
recordings with motion if pre-set time interval is 00:05:00.
Configurable delay time: 00:00:05~23:59:59.
Time Lapse
Select “ON”, press “OK”, to set the interval; camera will shoot
pics or video clips automatically upon the interval user set.
Object motion can still trigger the camera to take photos/
videos if PIR Switch is ON.
Configurable interval: 00:00:05~23:59:59.
Timer1
Select “ON”, press “OK”, to set the beginning time and end
time (hour/minute); camera will only work during the time user
set.
i.e.: 06:00 – 10:00; camera only works during 06:00 – 10:00
Timer2
Select “ON”, press “OK”, to set the beginning time and end
time (hour/minute); camera will only work during the time user
set.
i.e.: 15:00 – 18:00; camera only works during 15:00 – 18:00