Unlimited – default
1~99 – Optional
i.e.: user chooses 50, then camera will only send photos 50 times every day.
Each time, camera will send to all entered emails/ phones/ FTP accounts. All
the rest photos upon triggers will only be stored in SD card.
Daily – SMS commands sent from the APP will be executed upon next motion
trigger; otherwise camera execute commands based on the Daily Report time.
Recommended setting to reduce battery consumption!
Instant – SMS control is enabled all the time. SMS commands sent from the
APP (including “Get a Picture”) will take effect immediately.
Caution! This setting depletes the batteries very quickly, we advise you
to use external power supply or 12V/ 2A DC adapter!
OFF – no Daily Report.
ON – select ON for setting the time when you want camera to send you the
Daily Report.
Daily Report contains: Device IMEI Number, CSQ (Signal Strength) 0~31,
Camera ID, Temperature, Date & Time, Battery Left Volume, SD Card Info,
Total Pics taken by Cam and Send Times.
You can ignore below description if your SIM card already has been activated,
“Pls enter PIN-Code” will not pop up.
1. Camera will check if inserted SIM card is activated during signal search in
“Test” mode.
2. If SIM is not activated, “Pls enter PIN-Code” will pop up on screen after
signal search.
3. Then “SIM PIN” will turn to be configurable in “4G” page of Menu.
SETUP→MENU→4G→SIM PIN
4. Enter PIN code in “SIM PIN”; camera will auto power off. Camera will
activate SIM card automatically during signal search when you restart the
camera after you enter the PIN code.
Note!
● “Pls enter PIN-Code” will pop up again if wrong PIN code is entered.
● Re-try your PIN code if you see “Pls enter PIN-Code” after signal search.
● SIM is normally limited to 3 attempts then it will be locked. We suggest you
confirm your PIN code before 3
rd
attempt.
● Insert the SIM card into your phone to unlock it using PUK code if it has
been locked.
To Next Page
Loading...