19
Pro-C Controller
Selecting Specific Days of the
Week to Water
1. Press the Press the
button to activate
a particular day of
the week to water
(the display always
starts with Monday). Press the button to
cancel watering for that day. After pressing
a button the display automatically advances
to the next day. A indicates a water day.
A indicates a no water day.
2. Repeat step 1 until desired days have
been selected.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Selecting Interval Watering
This feature is convenient if you want to have
a more consistent watering schedule without
having to worry about the day of the week or
the date. The interval you select is the amount
of days between watering. The days remaining
indicates how many days until the next
watering. For example if you select an interval
of 2 with 1 days remaining, watering will
begin tomorrow at the scheduled time.
1. With the cursor on
Sunday, press the
button. Interval days
left, Odd and Even
will appear in the
display.
2. Interval is flashing
press the button.
The display will
increment the
interval.
3. Press
, the
number of days will
be flashing. Use the
and buttons
to select the number
of days left until the
next watering.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Selecting Odd or Even Days to Water
This feature uses a numbered day of the month
for watering instead of specific days of the
week (odd days 1st, 3rd, 5th, etc.; even days
2nd, 4th, 6th, etc.).
1. Using the instructions for Interval
Watering, set the interval to one.
2. Press the
button
until the cursor is
on either EVEN or
ODD in the display.
Select whichever
you choose as No Water Days. If you
select ODD as No Water Days,then the
controller will only water on even days of
the month. Conversely, if you select EVEN
as No Water Days then the controller will
only water on odd days of the month.
NOTE: The 31st of any month and February 29th
are always “off” days if Odd watering is selected.
After programming, set dial to RUN to
enable automatic execution of all selected
programs and start times.
Weather Sensor Bypass
With this built-in feature,
there is no need for an
additional manual bypass
switch when using rain sensors
(the Pro-C works with the
Hunter Mini-Clik
®
, plus some
other rain, wind, and freeze sensors on the
market today). If the system is preventing
system operation (or no sensor is installed
and the switch is in the ACTIVE position),
SENSOR OFF will be displayed. Simply
move the switch to BYPASS and the weather
sensor will be bypassed. This allows you to
use the system.
RAIN SENSOR
BYPASS
ACTIVE
SYSTEM
To Next Page
Loading...
Need help?
General
