5
6
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
S
l
i
d
e
c
a
n
o
p
y
o
v
e
r
d
o
w
n
r
o
d
a
n
d
w
i
r
e
s
.
Place the downrod ball into
the slot in the ceiling bracket.
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
4
STEP
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
5
STEP
Lower the adapter cover until it rests ush
against the motor housing.
Fan style may vary.
Note:
Fan style may vary.
Note:
To Next Page
Loading...
Need help?
General