Hunter SET & SAVE 44155C - Setting Day and Time

25
The default for this thermostat setting is in a
12 hour format. You can change the format to
24 hour format by pressing Day/Time and then
Program.
The AM/PM indicator will be off when the thermostat is
in 24 hour mode.
Setting day and time:
1. Press
Day/Time. (AM/PM and current hour will
ash)
2. Press
Up or Down to adjust the setting.
3. Press
Day/Time again to adjust the minute
setting.
4. Press
Day/Time again to adjust the day of the
week.
5. Press
Day/Time to return to the normal display.
You may also press Hold/Return at any time to return
to the normal display.
SETTINGS, CONT.