Hunter Shady Grove - Motor Housing and Blade Installation; Installing the Motor Housing; Assembling Fan Blades to Arms; Attaching Blade Arms to Motor

5
6
1886
1886
Ceiling Bracket Hanging Fan Wiring Motor Housing Blades Light
Installing the Blades:
Installing the Motor Housing
1
STEP
2
STEP
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
With a Phillips head screwdriver, install
the four motor housing screws found in
the
hardware bag. Tighten all four
screws securely.
x4
bag
Notch
Indentation
Motor Housing
Screw
Installing the Bulbs and Glass
Assembling the Light
Fan style may vary.
Note:
Lightly attach the blade arms to the
motor with the blade arm screws,
then securely tighten after both
screws are attached.
Repeat x5
Fan style may vary.
Note:
x15
x15
Repeat x5
bag
bag
Blade Screw
Blade Nut
Secure each blade to a blade iron as shown using the blade nuts and grommets, found in
the hardware bag, and the blade assembly screws, found in the hardware bag.
x15
Grommet
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
x10
Blade Arm Screw
bag