Hunter SmartWeight Pro - Page 7

2.2.9. Turning Power ON / OFF
PUSH BUTTON SWITCH
The balancer is equipped with a push buon power switch located on the le
side of the LCD support. Use this switch for normal shut down and restarng
procedures.
CAUTION
Always use the power buon on the LCD support turn on/o in
order to prevent data loss.
MAIN POWER SWITCH
The main power ON/OFF switch is located on the back of the balancer cabinet.
To power the balancer “ON,” press the “I” side of the ON/OFF switch. To turn all
power the balancer “OFF,” press the “O” side of the ON/OFF switch.
2.2.10. Equipment Specifications
Only a Hunter Factory-Authorized Representave should perform installaon. This equipment contains no operator serv-
iceable parts. All maintenance and repairs must be referred to a qualied Hunter Service Representave.
Table 1. Equipment Specicaons
Electrical
Voltage: 230VAC +10% / -15%, 1phase, 50/60 Hz, power cable includes NEMA 20
amp plug, L6-20P
Amperage: 10 amperes
Waage: 3450 was (peak)
Air
Air Pressure Requirements: 100-175 PSI (6.9-12 bar)
Approximate Air Consumpon: 4 CFM (110 Liters/Minute)
Atmospherics
Temperature: +32°F to +122°F (0°C to +50°C)
Relave Humidity: Up to 95% Non-condensing
Altude: Up to 10,000 . (3048 m)
SmartWeight
®
Pro Operations Manual
Page 7 of 11