22
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the
button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B or C by pressing the program.
3. The station number will be flashing. Press the
button to scroll
through the stations and use the
or buttons to adjust the
station run times. (If no buttons are pressed during step 2 or 3, the
controller will automatically begin program A.)
4. Press the
button to scroll to the station you wish to begin with.
After a 2 second pause, the program will begin.
This feature is great for a quick cycle when extra watering is needed or if
you would like to scroll through the stations to inspect your system.
Hunter Quick Check™
Irrigation professionals are continuously looking for ways to more
efficiently and effectively diagnose programs in the field. Instead of having
to physically check each field wiring circuit for potential problems, the
user can run the Hunter Quick Check™ circuit test procedure. This circuit
diagnostic procedure is very beneficial because of its ability to aid in
quickly identifying "shorts" commonly caused by faulty solenoids or when a
bare common wire touches a bare station control wire.
To initiate the Hunter Quick Check test procedure; Press the
, , ,
and
buttons simultaneously. In the standby mode, the LCD will display
all segments (helpful when troubleshooting display problems). Press the
button to begin the Quick Check test procedure. Within seconds, the
system searches all stations in an effort to detect a high current path through
the station terminals. When a field wiring short is detected, an ERR symbol
preceded by the station number will momentarily flash on the controller
LCD display. After the Hunter Quick Check completes running this circuit
diagnostic procedure, the controller returns to the automatic watering mode.
Clearing the Controller's Memory/ Resetting the Controller
If you feel you have misprogrammed the controller, there is a process
that will reset the memory to factory defaults and erase all programs and
data that has been entered into the controller.
1. Press and hold down the
, and buttons.
2. Press and release the reset button in the lower wiring compartment.
3. Release the
, and buttons. The display should now show
12:00AM. All the memory has been cleared and the controller may
now be reprogrammed.
PROGRAMMING THE CONTROLLER (continued) ..............................................................
To Next Page
Loading...
Need help?
General
