Product Overview
Step 3: Navigating the WAND Module
with the X2 Controller
Locate the following:
A. Wi-Fi status LED
B. Wi-Fi setup button
C. WAND serial number
The serial number is used to enable
Hydrawise management for the WAND
Module. You will be prompted to enter
the serial number during the online setup
process when adding the controller to your
Hydrawise account.
Leave the WAND Module installed with the
dial in the RUN position during setup to
remain connected to Hydrawise Soware.
If the WAND Module is removed, the
controller will revert to the programs
and settings congured via the dial
and buttons.
To ensure the X2 Controller operates
with Hydrawise, you must have the dial
in the Run position. The controller will not
operate remotely if the dial is in any
other position.
5
hunterindustries.com
To Next Page
Need help?
General
