HunterDouglas PowerView Pebble User Manual

Resetting window covering programming
This reset erases Network information stored in the window
covering, including GROUP assignments, preventing any input
device from operating the window covering. Its primary use is
during installation to correct GROUP and Network assignments.
This reset does not affect travel limits.
1. Press and hold the programming button for 12 seconds.
The window covering will move slightly once after 6 seconds,
then again after 12 seconds. Release the button.
2. Refer to “Join a window covering to a GROUP” on
page 19 to program the window covering to a group.
22
PROGRAMMING
What’s the Difference?
Paired remote Duplicate remote
Same PowerView
®
Shade
Network I.D. as original remote.
Same PowerView Shade
Network I.D. as original remote.
Can be programmed differently
from original remote.
An exact duplicate of
original remote.
Can control a different set
of window coverings and/or
different GROUPS.
Must control the same set
of window coverings and/or
GROUPS.
Basic Operation
23

HunterDouglas PowerView Pebble Specifications

General

Brand	HunterDouglas
Model	PowerView Pebble
Category	Remote Control
Language	English