UltraScan PRO Supplemental Manual for EasyMatch QC Ver. 2.0
18
Sensor > Configure Multi Mode
This command is used to set up the process by which the instrument can standardize and read in two
separate but similar modes when the standardization and read commands, respectively, are given.
The following screen first appears that allows you to indicate how you would like the multimode
readings to be performed.
Figure 17. Configure Multi-Mode
When this screen first opens, the standardization modes you have configured for your instrument
(using SENSOR > SET MODES) are listed in the AVAILABLE MODES box. Click on the first mode you wish
to use and then click the INCLUDE button to move the mode from the Available Modes box to the
Selected Modes box. Only modes that are similar enough to the already-selected mode that no user
intervention is required for the dual measurements will remain available. Select the second desired
mode and click INCLUDE again to include it. Click OK. Then, when the OPTIONS > READ METHOD
menu is set as MULTIPLE READ MODE, the instrument will be standardized in the two modes when
you initiate standardization and will read in the two modes when you initiate readings. The multiple
readings are placed in the job as separate measurements.
Figure 18. Select Modes
Place it as close to the lens as possible when measuring regular transmittance.
To Next Page
Loading...
