Need help?Do you have a question about the HunterLab UltraScan VIS and is the answer not in the manual?
General| Wavelength Interval | 10 nm |
|---|---|
| Observer Angles | 2° and 10° |
| Data Interface | USB, RS-232 |
| Measurement Geometry | d/8° (diffuse illumination, 8° viewing) |
| Light Source | Pulsed Xenon flash lamp |
| Measurement Time | 1 second |
| Sphere Diameter | 152 mm (6 inches) |
| Photometric Range | 0-200% reflectance |
| Repeatability | ±0.01 ΔE*ab for white tile |
| Inter-Instrument Agreement | 0.15 ΔE* CIE Lab |
| Aperture Sizes | 3 mm, 6 mm, 10 mm |
| Measurement Area | 3 mm, 6 mm, 10 mm |
| Color Scales | CIE L*a*b*, CIE L*C*h°, Hunter Lab, CIE XYZ, Yxy, CIE Yxy |
| Illuminants | D65, A |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Weight | 24 lb (10.9 kg) |
Describes the port at the front of the sensor used for sample placement and measurement.
Explains the compartment for measuring transmitted color of solids or liquids.
Covers Ganz-Griesser calibration using a 400-nm UV filter for fluorescent samples.
Step-by-step guide to installing the EasyMatch QC software from the CD.
Instructions for activating the software license using a Key ID or Key File.
Procedure for installing and configuring the UltraScan VIS sensor within the software.
Explains the process of standardizing the instrument for accurate photometric measurements.
Instructions for calibrating the UV filter for measurements involving fluorescence.
Guides on performing and calculating transmission haze measurements.
Procedure to test the instrument's measurement repeatability.
Instructions for replacing the xenon flash lamp module.
Details wavelength range, resolution, accuracy, and repeatability.
To Next Page
