41
Refer to diagram on inside front cover for Doppler Measuring Sites and
Recommended Probes.
During
Use
An automatic noise reduction feature operates on low level signals to improve
sound quality.
To replace battery see diagram on page 2.
After
Use
1. Press and release the On/Off button. If you forget to switch the unit off, it will
automatically switch off after 3 minutes.
2. Refer to the cleaning section before storing or using the unit on another
patient.
3. Store unit together with probe and accessories in the soft carry case
provided.
The control unit and the body of the probe are robust and require no special
handling. However, the probe tip is delicate and must be handled with care.
Cleaning
Remove excess gel before replacing the probe. Clean with a damp cloth
impregnated with mild detergent. Do not allow fluid to seep into either unit.
For disinfection use a soft cloth with Sodium Hypochlorite 1000ppm or alcohol.
Alcohol saturated swabs can be used on the probe tip.
Please be sure to check your local control of infection policies, or any equipment
cleaning procedures.
Phenolic, detergent based disinfectants containing cationic surfactants, ammonia
based compounds, or antiseptic solutions such as Steriscol or Hibiscrub should
never be used on any part of the system.
Coupling
Gel
Use water-based ultrasound gel ONLY.
FD1+
&
FD3
Gel not required when probe used under water.
GGEENNEERRAALL
OOPPEERRAATTIIOONN
&&
MMAAIINNTTEENNAANNCCEE
Means:
Attention
consult
this
manual.
Refer
to
Safety
Section.
EENNGGLLIISSHH
((UUSSAA))
To Next Page
Loading...
