5
Mode
Selection
(FD2
only)
Press
Mode
button to select mode.
Use
of
Manual
Mode
1. Press and hold
Start/Stop
button
and immediately count the
audible heart beats, counting
the first beat as the button is
pressed. The LCD displays the
flashing clock symbol and the
FHR reading is shown as three
dashes.
2. Release the
Start/Stop
button
immediately on the count of 10
(i.e. After nine beat intervals).
The
FD2
will automatically
calculate the derived FHR
averaged over the 10 beat
period and display the result.
This rate value is retained until
the measurement is repeated or
the unit is switched off. If the
button is held for a period less
than about 3 seconds the
display will clear the previous
rate value and reset.
Connection
to
Printa
(FD2
Only)
Hard copy printing is automatically
selected when the plug of the interface
buffer box is inserted into the RS232
socket on the top panel of the
FD2
.
Printing is then initiated by using the
Start/Stop
button.
Probes
OP2HS 2MHz ±1%
OP3HS 3MHz ±1%
OOPPEERRAATTIINNGG
IINNSSTTRRUUCCTTIIOONNSS
OOBBSSTTEETTRRIICCSS
Huntleigh Healthcare's standard terms and
conditions apply to all sales. A copy is
available on request.
These contain full details of warranty terms
and do not limit the statutory rights of the
consumer.
SSeerrvviiccee
RReettuurrnnss
If for any reason your Dopplex Unit is being
returned, please:
1. Clean the product, as described
in the cleaning section.
2. Pack it in suitable packing.
3. Attach the decontamination
certificate (or other written
statement declaring that the
product has been cleaned) to
the outside of the package.
4. Mark the package "Service
Department - Fetal Dopplex /
Fetal Dopplex II / Fetal Dopplex III".
UUKK
For further details refer to the NHS document
HSG(93) 26.
For service, maintenance and any questions
regarding this, or any other Huntleigh
Healthcare Dopplex product, please contact:
Huntleigh Healthcare Ltd
Diagnostic Products Division
35 Portmanmoor Road
Cardiff
CF24 5HN UK
Tel : +44 (0)29 20485885
Fax: +44 (0)29 20492520
Or your local distributor.
Manufactured in the UK by Huntleigh
Healthcare Ltd. As part of the ongoing
development programme the company
reserves the right to modify specifications
and materials without notice.
Sonicaid, Dopplex, Huntleigh and 'H' logo are
registered trademarks of Huntleigh
Technology Ltd 2004.
©Huntleigh Healthcare Ltd 2004
WWAARRRRAANNTTYY
&&
SSEERRVVIICCEE
EENNGGLLIISSHH
To Next Page
Loading...
Need help?
General
