There is also Rigid tapping available. This is not in the
sample code, however here is the information for the canned
cycle.
Here is an example line of code for rigid tapping
M29
G84 X0. Z-.5 P1. Q.25 F.07692 S250
Q is Peck depth.
The next process is boring.
This follows the same principles as OD turning and facing.
T0404
G92 S1000
G97 M3 S500
G54
G0 G95 Z.25
X.5
G96
G71 P5 Q6 U.005 W.002 F.005 S1000
N5 G1 X.85 Z.05
Z0.
X.75 Z-.05
Z-1.
N6 X.5
G0 Z.25 X.5
G70 P5 Q6 F.002 S1000
G0 Z.25 X.5
To Next Page
Loading...
