Utilizing the G109 map properly for drilling
First call the proper tool and change modes.
T0606
G109 (TURNING MAP)
M131 (MILLING MODE)
G7 (RADIUS PROGRAMMING)
G97 M33 S1500 (TURN SPINDLE ON AT FIXED RPM)
G54
Now that the proper tool has been called up in the proper
mode an approach can be designated.
G0 Z.25 C0.
X.75
Z-.75
Now a canned cycle can be executed.
G98 G81 X.75 Z-1.625 F.002 S1500 (DRILLING CANNED CYCLES)
C45.
C90.
C135.
C180.
C225.
C270.
C315.
G80 (CANCEL CANNED CYCLE)
G00 X2.25 Z.25
G8 (DIAMETER PROGRAMMING)
M130
M35 (STOP LIVE TOOL)
In this mode all canned cycles can be executed and are
available.
To Next Page
Loading...
