Set all the settings as displayed above. The only setting
that may change is the ISNC G Code Mode. (see next page)
There are Two settings for G code interpertation.
The easiest way to think about these two modes is to imagine they are dialects, some of the
codes will mean different things, however all the functionallity exist in both modes, you may just need
to use a different code.
STOP!
Some codes are only available in certain modes. The mode of ISNC G-code will determine how
to program the machine.
Mode A is an older style of code and may not have all the functionality that Mode B will
contain. Mode A’s purpose is to add flexability. Mode A may allow programs from an older
control that is not a Hurco control to run on a hurco control will little to no modification.
Mode B is the Prefered way to program a Hurco Turning
Center!
ALL EXAMPLES WILL BE IN MODE B!
To Next Page
Loading...
