Hurco TM8 - Page 5

Most codes will retain the same functionallity.
These codes Containt the same functionality between modes, however may still require different
parameters.
G00, G01, G02, G03, G04, G06, G07, G08, G09, G10, G11, G17, G18, G19, G20, G21, G28, G40, G41, G42,
G53, G54-G59, G54.1, G61, G64, G65, G66, G67, G70, G71, G72, G73, G74, G75, G76, G80, G81, G82,
G83, G84, G85, G86, G87, G88, G89, G93, G96, G97.
This table will show the main differences
Mode A
Mode B
G50
Max RPM
G92
Max RPM
G98
Per Min Feed
G94
Per Min Feed
G99
Per Rev Feed
G95
Per Rev Feed
No Code
G98
Return to Initial Level
No Code
G99
Return to R point Level
G94
End Face Turning Cycle
G79
End Face Turning Cycle
G92
Thread Cutting Cycle
G78
Thread Cutting Cycle
No Code
X,Y,Z Coordinates Abs
G90
Absolute Programming
No Code
U,V,W Coordinates Inc
G91
Incremental
Programming
G90
Outer/Inner Cutting
Cycle
G77
Outer/Inner Cutting
Cycle
G32
Thread Cutting
G33
Thread Cutting
The table above can be used as a reference guide to change
codes to alter an existing program.