2 - Record of Changes 704-0212-209 VM Series Maintenance and Safety Manual
704-0212-208, November 2010, ECN 17135
Revised by: K.Gross
Approved by: D. Skrzypczak, November 2010
704-0212-207, March 2009, ECN 16535
Revised by: K.Gross
Approved by: P. Baechle, D. Skrzypczak, March 2009
704-0212-206, October 2008, ECN 16541
Revised by: K.Gross
Approved by: P. Baechle, F.Gross, D. Ornelas, D. Skrzypczak, October 2008
Changes
• Updated Machine Electrical Cabinet and Operator Control Console sections of Machine
Components chapter with USB drive on console.
• Updated Safety Circuits section of Operation Requirements chapter for CE2009.
• Expanded Spindle Chiller section in Maintenance chapter.
• Expanded Tool Lock Pin and Tool Gripper Fingers section in Maintenance chapter.
• Added Chip Conveyor Paddle Screws and Chains section in Maintenance chapter.
• Added Enclosure Window section in Maintenance chapter.
Changes
• Revised table information for VM10 series, VM20, and VM30 per revised
technical specifications:
VM10 757-4002-425, Rev E
VM10G 757-4002-356, Rev G
VM10P 757-4002-497, Rev E
VM20 757-4002-426, Rev E
VM30 757-4002-427, Rev E
Changes
• Added information for VM10 series, VM20, and VM30 per technical
specifications:
VM10 757-4002-425, Rev D
VM10G 757-4002-356, Rev F
VM10P 757-4002-497, Rev D
VM10U 757-4002-507, Rev A
VM20 757-4002-426, Rev D
VM30 757-4002-427, Rev D
To Next Page
Loading...
