2 - 10 Operation Requirements 704-0212-209 VM Series Maintenance and Safety Manual
Proper Operation and Maintenance
This section addresses the proper operation of the machine. The information presented
here is not a substitute for operator training, skill, and good judgment. Hurco does not
accept any liability for operator error.
Training for Operators
Hurco or a Hurco-authorized distributor must train all machine operators. Hurco offers
classes to demonstrate the programming capabilities of its CNC system. The training
classes provide hands-on development of part programs.
Study this manual before attempting to operate the machine and become familiar with
machine functions and safety features. Review all caution and warning messages, as well
as all warning and instruction plates or decals on the machine.
Setup
Follow these precautions during machine and production setup:
• Perform all setup work with the Emergency Stop engaged. Never put your
hands near a part being machined.
• Clamp the fixtures and workpiece securely before starting the machine.
Loose objects such as wrenches and chuck keys can become flying projectiles
if not removed before starting the machine.
• Wear gloves or use a shop cloth when handling tooling.
• Inspect tools and tool holders frequently. Use tools that are properly
sharpened and in good condition.
• Never start the machine when the cutter is in contact with the workpiece.
Make sure the direction of spindle rotation is correct to prevent cutter
breakage. Rotate the spindle clockwise for right-hand tools, and
counterclockwise for left-hand tools.
• Keep the work area well-lighted. Adjust lamps so that light does not shine
directly into the operator’s eyes.
• Make certain all guards are in place before beginning operation.
To Next Page
Loading...
