Hurco VM30 - Record of Changes

VM Series Maintenance and Safety Manual 704-0212-209 Record of Changes — 1
RECORD OF CHANGES
704-0212-209, February 2012, ECN 17280
Revised by: K.Gross
Approved by: P.Baechle, J.Bryan, J.Higgason, W.Kline, D.Skrzypczak, January
2012
Changes
704-0212-209 Rev B:
Added information for VM5 per technical specifications:
• VM5: 757-4002-605, Rev B
704-0212-209 Rev A:
Added information for VM5 per technical specifications:
• VM0: 757-4002-605, Rev A
Updated VM10 series, VM20, and VM30 machines per revised technical specifications:
• VM10: 757-4002-425, Rev H
• VM10: 757-4002-356, Rev H
• VM10P: 757-4002-497, Rev G
• VM10U: 757-4002-507, Rev D
• VM20: 757-4002-426, Rev G
• VM30: 757-4002-427, Rev F
Added “Inspect the Clamping System Pneumatic Lines” section to the Trunnion Table
section in the Maintenance chapter. This information applies to the VM10U. Removed
the “Maintain the Hydraulic Pressure of the Clamping System” section of the VM
Maintenance chapter.
Removed information for VM1, VM1G, VM1P, VM2, and VM3.
Removed information for Floppy Disk Drive on console. Replaced with USB port.