Hurco winmax - Jogging the Axes Manually; Indexing the Turret Using Console Keys

5 - 6 Machine Operation Basics v546GS Getting Started—WinMax Lathe Max Control
Jogging the Axes Manually
Follow these steps to manually jog the axes:
1. Select an axis with the Axis Select Switch.
2. Select a hand wheel multiplier key. The key illuminates when selected.
3. Use the Jog Feed Keys to jog the axis direction by selecting either + or –.
4. Override the programmed axis feedrate by turning the Jog Feed Override dial.
5. Rotate the Incremental Jog Wheel to manually jog the axes.
Indexing the Turret using Console Keys
To index the turret using the plus (+) or minus (-) Turret console keys,
1. Press the Manual console key to access the Manual screen.
2. Calibrate the machine. Refer to Calibrate the Machine, on page 5 - 3 for
details.
3. Adjust the speed at which the turret moves using the Rapid Override console
knob.
On TMX, TMX MY, and TMX MYS machines the Rapid Override also
affects the indexing speed of the turret; however, the Maximum
Rapid rate set in Program Parameters does not affect the indexing
speed of the turret.
When the Rapid Override is set at 0% the turret will still move as the
override minimum for the turret indexing speed is 1%.
TMX machines
• Rapid Override at 100% - Turret rotates at approximately 42
RPM (Maximum Speed).
• Rapid Override at 1% - Turret rotates at approximately 0.42 RPM
(Minimum Speed).
TMX MY and TMX MYS machines
• Rapid Override at 100% - Turret rotates at approximately 83
RPM (Maximum Speed).
• Rapid Override at 1% - Turret rotates at approximately 0.83 RPM
(Minimum Speed).