WARNING! Drive must be engaged
as described below (see 4.32) to prevent
sudden engagement from causing tipping
up and loss of control of the vehicle, par-
ticularly on slopes.
5.4.3 Braking
-
chine until it stops.
Hydrostatic transmission
-
5.4.4 Reverse
IMPORTANT Reverse must only be engaged
when the machine has stopped.
IMPORTANT To proceed in reverse gear with
the cutting means engaged, it is necessary to
press and hold the consent button (see 4.7) so
as not to cause the engine to stop.
Mechanical transmission
Hydrostatic transmission
-
5.4.5 Grass cutting
-
-
as possible.
WARNING! This should always be per-
formed on both wheels, positioning them at
the same height WITH THE ENGINE OFF AND
CUTTING MEANS DISENGAGED.
-
– regulate the cutting height and speed (see
WARNING! When cutting on sloping
ground, the forward speed must be reduced
to ensure safe conditions (see 1A – C7-8-9).
5.4.6 End of mowing
-
altezza.
5.4.7 End of work
When the engine has stopped, close the fuel
WARNING! To avoid backfire, put the
accelerator in the «SLOW» position for 20
seconds before stopping the engine.
IMPORTANT To keep the battery charged, do
not leave the ignition key in the «ON» or «HEAD-
To Next Page
Loading...
