fasteners into place.
3.3 FITTING THE SEAT (Fig. 3.3)
3.4 ASSEMBLY AND CONNECTING
HE BATTERY (Fig. 3.4)
is in place.
IMPORTANT Always fully charge the bat-
tery according to the instructions in the battery
booklet.
IMPORTANT To prevent the safety device in
the electronic circuit board from cutting in, never
start the engine until the battery is fully charged!
3.5 MOUNTING THE FRONT BUMPER
(if provided)
• Bumper Type “I” (Fig. 3.5)
• Bumper Type “Il” (Fig. 3.6)
3.6 FITTING THE SIDE DISCHARGE
CHUTE (Fig. 3.7)
-
sitioned in their seatings.
discharge chute.
and on the side discharge chute, so that it
and rotate the pin until it is possible to bend the
WARNING! Check that the spring works
correctly and keep the side discharge chute
securely lowered. Make sure that the pin is
fitted properly to prevent it from falling out
accidentally.
3.7 REPOSITIONING THE ANTI-CHIPPING
WHEELS (Fig. 3.8)
4. CONTROLS AND INSTRUMENTS
4.1 STEERING WHEEL (Fig. 4.1 no.1)
4.2 THROTTLE LEVER (Fig. 4.1 no.2)
«CHOKE» cold start
for cold starts.
«FAST».
4.2a
(Fig. 4.1 no.2a)
To Next Page
Loading...
