What to do if Husqvarna 120e MARK II engine is flooded?
If the engine of your Husqvarna Chainsaw is flooded because of repeated starts with full choke after ignition, remove and clean the spark plug. Put the product on its side with the spark plug hole away from you. Pull the starter rope handle 6-8 times. Assemble the spark plug and start the product.
How to fix a clogged air filter in Husqvarna 120e MARK II Chainsaw?
If your Husqvarna Chainsaw's air filter is clogged, clean or replace it.
What to do if the fuel tank of my Husqvarna 120e MARK II is filled with chain oil?
If the fuel tank of your Husqvarna Chainsaw has been filled with chain oil, drain the fuel tank if you haven't tried starting the product. If you have already attempted to start it, it is recommended to speak to your servicing dealer.
What to do if I put chain oil in the fuel tank of my Husqvarna 120e MARK II Chainsaw?
If the fuel tank of your Husqvarna Chainsaw is filled with chain oil instead of the correct fuel type, drain the fuel tank and fill it with the appropriate fuel.
What to do if I used the wrong fuel type in my Husqvarna Chainsaw?
If you've used the wrong type of fuel in your Husqvarna Chainsaw, drain the fuel tank and refill it with the correct fuel.
General| Engine Type | 2-stroke |
|---|---|
| Engine Displacement | 38.2 cm³ |
| Power Output | 1.5 kW |
| Bar Length | 14 in |
| Weight (excluding cutting equipment) | 4.85 kg |
| Fuel Tank Volume | 0.3 liters |
| Chain Pitch | 3/8 in |
| Chain Gauge | 0.050 in |
| Weight (without cutting equipment) | 4.85 kg |
| Sound power level | 113 dB(A) |
| Oil Tank Volume | 0.2 L |
| Vibration level (front/rear handle) | 4.6/4.5 m/s² |
To Next Page