Husqvarna 240i - Accessories; Guide Bar and Saw Chain Combinations

240i
Saw chain/guide bar
Recommended bar lengths, in/cm 14-16-18/35.6-40.6-45.7
Usable cutting length, in/cm 13-15-17/33.7-37.6-43.1
Type of drive sprocket/number of teeth 6
Maximum chain speed / (Normal mode), m/s 11.8
Maximum chain speed / (SavE mode), m/s 9.4
Accessories
Guide bar and saw chain combinations
The cutting attachments below are approved for the
product.
Guide bar Saw chain
Type Length, in Pitch, in Gauge, mm Max. nose ra-
dius
Type Drive link
count
578186652 14 3/8" mini 1.3 7T
Husqvarna
S93G
(585422852)
52
578186656 16 3/8" mini 1.3 7T
Husqvarna
S93G
(585422856)
56
597533238 18 3/8" mini 1.3 7T
Husqvarna
S93G
(585422862)
62
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain.
A Husqvarna file gauge makes sure that you get the
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to for more information.
93
5/32 in/4.0
mm
60° 30° 0°
0.025 in/
0.65 mm
596 63
89-01
596 63
84-01
1951 - 001 - 23.09.2022 41