6
502 50 18-01
Put the oil tank and the saw housing
together.
Tighten the three screws and t the other
parts in the reverse order as set out for
dismantling.
Put the oil tank and the saw housing
together. Do not forget the oil screen (A).
Make sure it is clean and not damaged.
Check that the tank venting lter (B) is clean.
Tighten the three screws.
Assemble the remaining components in the
reverse order as set out for dismantling.
Telescopic tube
Dismantling
Remove the saw head from the telescopic
tube.
Remove the telescopic tube from the
clutch cover.
Telescopic tube
Dismantling
Remove the saw head from the telescopic
tube as described above.
Remove the telescopic tube from the
clutch cover.
Loosen both screws (A) (one on each
side).
Loosen the screws (B).
Pull off the telescopic tube and allow the
throttle control to remain suspended in its
cabling.
Pull out the drive shaft (A) and the plastic
pipe (B) from the engine end of the
telescopic tube.
Then also pull out the long drive shaft. Note
that the shaft has a small 48 cm circlip at the
shaft end. The shaft can therefore be slid out
from the other direction.
Pull out the drive shaft (A), the plastic
pipe (B) followed by the long drive shaft
from the engine end of the telescopic
tube.
To Next Page
Loading...
Need help?
General
