Why is my Husqvarna Chainsaw difficult to start?
If your Husqvarna Chainsaw is hard to start, try adjusting the L-screw, checking if the air filter is blocked, or inspecting the choke for proper function. It could also be due to a worn choke pivot or butterfly. Additionally, examine the fuel filter and fuel line for any blockages. In some cases, a seized piston ring or a blocked impulse channel might be the cause.
Why is the carburettor leaking fuel on my Husqvarna Chainsaw?
If the carburettor of your Husqvarna Chainsaw is leaking fuel, check for a loose or faulty fuel pipe, a hole in the diaphragm, or a worn needle valve. The issue might also stem from a sticking needle valve assembly, a needle valve set too high, a leak in the metering system, or a loose cover on the carburettor pump side.
Why is my Husqvarna Chainsaw flooding when the motor is off?
If your Husqvarna Chainsaw is flooding when the motor is not running, it could be due to a worn needle valve, a needle valve set too high, or a needle valve assembly sticking.
What causes my Husqvarna 362XP Chainsaw to idle too rich?
If your Husqvarna Chainsaw is idling too rich, try adjusting the L-screw. Other potential causes include a worn needle valve or lever, a needle valve set too high, a leaking control diaphragm/cover plate, or a needle valve assembly sticking.
Why does the L-screw on my Husqvarna 362XP require constant adjustment?
If the L-screw on your Husqvarna Chainsaw requires constant adjustment, it could be due to a blocked fuel line, a needle valve set too high, or a needle valve assembly sticking. Other potential causes include a leak in the metering system, a leaking control diaphragm/cover plate, a faulty diffuser jet, or a crankcase leak.
Why is there too much fuel at idling on my Husqvarna 362XP?
If there is too much fuel at idling in your Husqvarna Chainsaw, it could be due to a needle valve set too high, a needle valve assembly sticking, a damaged metering system, or a worn needle valve. A leaking control diaphragm/cover plate or an incorrectly assembled metering system could also be the cause.
What to do if my Husqvarna 362XP will not idle?
If your Husqvarna Chainsaw will not idle, consider these possible solutions: Adjust the L-screw. Check for a leaking air intake, loose carburettor mounting bolts, or a loose or faulty fuel pipe. A blocked fuel filter, fuel line, or fuel tank ventilator could also be the reason. Other potential causes include a stiff throttle valve pivot, a sticking throttle cable, a defective throttle return spring, a bent throttle stop, or a faulty diffuser jet.
Why does my Husqvarna Chainsaw idle when the L-screw is closed?
If your Husqvarna Chainsaw idles when the L-screw is closed, it might be caused by a worn needle valve, a leaking control diaphragm/cover plate, a needle valve assembly sticking, a worn needle valve lever, or a faulty diffuser jet.
General| Engine Type | 2-stroke |
|---|---|
| Weight (excl. cutting equipment) | 5.8 kg |
| Chain pitch | 3/8" |
| Chain gauge | 0.050" |
| Recommended bar length | 40-50 cm (16-20 inches) |
To Next Page
