Husqvarna 362XP - FUEL HANDLING; Fuel; Mixing; Two-stroke oil

SAFETY EQUIPMENT
English – 15
Throttle lock
1. Remove the tank unit from the motor unit. See page 35.
!
WARNING!
The fuel that is used in the chainsaw
poses the following hazards:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
2. Press out the throttle lock pivot (A) with the help of a
driver. See fig. 12.
3. Twist the throttle lock as shown in fig. 13 and lift it out of
the hand grip together with the spring.
4. Press out the throttle lever pivot (B) with the help of a
driver. See fig. 12.
5. Lift out the throttle lever and cable and remove the cable.
Dismantling
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
BA
C
D
E
Reassembly
1. Assemble the throttle lever and cable and locate them in
the tank unit. Ensure that the cable lever arm (E) is
between the lip (D) and the under-side of the hand grip.
See fig. 15.
2. Press home the throttle lever pivot (B) with the help of a
driver. See fig. 12.
3. Locate the spring in the recess in the throttle lock. Hold
the spring in place and locate the throttle lock in the
recess in the hand grip. See fig. 16.
4. At the same time, arrange the throttle return spring as
shown in fig. 16.
5. Twist the throttle lock so that the catch (E) can pass down
beside the throttle lever inside the hand grip, as shown in
fig. 13.
6. Press in the throttle lock pivot (A) with the help of a driver.
7. Refit the tank unit onto the motor unit. See page 36.
Inspection
Clean the components and check the following:
1. The throttle cable and lever arm are undamaged and run
freely.
2. The lock activation mechanism is not worn. See C in
fig.14.