Husqvarna 372XPG X-Torq - KEY TO SYMBOLS; Symbols on the machine; Symbols in the operators manual

To Next Page

To Previous Page

KEY

O SYMBOLS

–

English

Symbols on the mac

hine:

ARNING! Chain saws can be

dangerous! Careless or incorrect use

can result in ser

ious or fatal injury to the

operator or others.

Please read the operator’s manual

carefully and mak

e sure you understand

the instructions before using the

machine.

Always wear:

• Approved protective helmet

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with

applicab

le EC directives.

Noise emission to the environment

according to the European Comm

unity’s

Directive. The machine’s emission is

speciﬁed in chapter Technical data and

on label.

WARNING! Kickback may occur when

the nose or tip of the guide bar touches

an object, and cause a lightning f

ast

reverse reaction, kicking the guide bar

up and towards the operator. May cause

serious personal injury.

Chain brake, activated (right) Chain

ake, not activated (left)

Decompression v

alve:

The valve is

to reduce the pressure in the cylinder and

mak

e starting easier. You should always

use the decompression valve when

starting the machine.

Ignition;

choke:

Set the choke control

in the chok

e position. This should

automatically set the stop switch to the

start position.

Adjustment of the oil pump

If your machine bears this symbol it is

equipped with heated handles

Other symbols/decals on the machine refer to special

cer

tiﬁcation requirements for certain markets.

Symbols in the operator’

manual:

Switch off the engine b

y moving the stop

witch to the STOP position before

carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be

rn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

The chain brake must be engaged when

the chain sa

w is started.