Husqvarna 372XPG X-Torq - Approved bar and chain combinations

English – 39
TECHNICAL DATA
Bar and chain combinations
The following cutting attachments are approved for the models Husqvarna 365 X-Torq, 372XP X-Torq and 372XPG
X-Torq.
Saw chain filing and file gauges
EC-declaration of conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain
saws for forest service
Husqvarna 365 X-Torq and 372XP/XPG X-Torq from 2010’s serial numbers and onwards (the
year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the
requirements of the COUNCIL’S DIRECTIVES:
- of May 17, 2006 "relating to machinery"
2006/42/EC
- of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.
- of May 8, 2000 ”relating to the noise emissions in the environment”
2000/14/EC.
For information relating to noise emissions, see the chapter Technical data. The following standards have been applied:
EN ISO 12100-2:2003, CISPR 12:2005, EN ISO 11681-1:2004
Notified body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has carried
out EC type examination in accordance with the machinery directive’s (2006/42/EC) article 12, point 3b. The certificates
for EC type examination in accordance with annex IX, have the numbers:
0404/10/2225 – 365 X-Torq, 0404/10/2224 –
372XP X-Torq, 372XPG X-Torq.
In addition, SMP, Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has certified conformity
with anne
x V of the Council’s Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
The certificates have the numbers:
01/161/099 - 365 X-Torq, 372XP X-Torq, 372XPG X-Torq.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna 25 May, 2012
Bengt Frögelius, Development director chainsaw R&D (Authorized representative for Husqvarna AB and responsible for
technical documentation.
Bar Chain
Length, inch Pitch, inch Gauge, mm Max. nose radius Type
Length, drive links
(no.)
16 3/8 1,5 11T Husqvarna H42 60
18 3/8 1,5 11T Husqvarna H42 68
20 3/8 1,5 11T Husqvarna H42 72
24 3/8 1,5 11T Husqvarna H42 84
28 3/8 1,5 11T Husqvarna H42
92