Husqvarna 540XP Mark III - Recommended cutting equipment

540XP Mark III
Equivalent sound pressure level at the operator’s ear,
dB(A)
103
Equivalent vibration levels, a
hveq
4
Front handle, m/s
2
3.7
Rear handle, m/s
2
5.1
Saw chain/guide bar
Type of drive sprocket/number of teeth 3/8" Spur/6, 0.325" Spur7
Saw chain speed at 133% of maximum engine power
speed, m/s.
26.6, 26.9
Accessories
Recommended cutting equipment
Chainsaw models Husqvarna 540XP Mark III have
been evaluated for safety according to EN ISO
11681-1:2011 (Machinery for forestry - Portable
chainsaw safety requirements and testing) and fulfill the
safety requirements when equipped with the below listed
guide bar and saw chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Note: The usable cutting length is usually 1 in less
than the nominal guide bar length.
Approved cutting equipment - 540XP Mark III
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
12/30 3/8 0.050/1.3 9T Husqvarna
S93G
45 Yes
14/35 52
16/40 56
12/30 0.325 mini 0.043/1.1 8T Husqvarna
SP21G
51 Yes
14/35 59
16/40 64
Pixel
Pixel is a guide bar and saw chain combination that is
more light weight and designated to offer more energy
4
Equivalent vibration level, according to ISO 22867, is calculated as the time-weighted energy total for vibration
levels under various working conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1 m/s
2
.
38 1679 - 006 -