Husqvarna 572XPG - General Safety Precautions - Page 14; Lubrication and Chain Oil

14 - English
WARNING! Ensure that the spring does
not y out and cause personal injury.
A
B
5.3 Assembly
1. Fit the hand guard with the sleeves on the chainsaw.
Attach the hand guard on the starter side (B). See
gure 8. Make sure that the sockets on the hand
guard are intact.
2. Grease the moving parts of the toggle joint (D) and
t the unit on the chainsaw. See gure 6.
3. Attach the screw to the hand guard on the clutch
side (A). Make sure that the sleeve in the socket is
in place. See gure 8.
4. Compress the spring using a conical screwdriver
6.5 mm wide and press it down with your thumb.
See gure 7. Hold the spring down with two ngers.
5. Grease and t the lever (A). See gure 6.
6. Grease and t the retaining bush (B) with spring (C).
See gure 6.
7. Make sure that the brake band is correctly positioned
in the recess in the crankcase. See gure 9.
8. Fit the chain guide-plate with screw (A). See gure 1.
9. Pull back the hand guard so that the chain brake
is disengaged.
10. Fit the cover over the chain brake mechanism.
Three screws (B). See gure 1. Fit the middle screw
last and hold two ngers steadily on the cover until
the cover is fully attached.
11. Grease the needle bearing. Fit the clutch drum (E)
with needle bearing (D) and chain drive sprocket
(C). See gure 2.
12. Fit the washer (B) and locking ring (A). See gure 2.
13. Fit the cylinder cover, chain and bar.
D
A
CB
Fig. 6
Fig. 9
6.5mm
Fig. 7
Fig. 8
Chain brake