Husqvarna 572XPG - Starting and Stopping - Page 21; Stopping the Engine

English - 21
WARNING! If the spring inside the spring
cassette is tensioned it can y up and
cause personal injury. Wear protective
glasses.
10 Starter
10.1 Dismantling
10.2 Cleaning and inspection
1. Clean all components.
2. Check the following for nicks and cracks:
• Starter cord.
• The dogs on the starter pulley.
• That the pawls on the ywheel are intact and that the
spring is back towards the centre and moves freely.
3. Grease the spring in the starter pulley with
Husqvarna UL 22.
Fig. 1
Fig. 2
Fig. 3
5. Unscrew the central bolt (C) with integrated washer.
Lift up the starter pulley (D). See gure 3.
6. If the starter cord is to be replaced, cut it o and
pull out the ends from the handle and starter pulley
using pointed pliers.
7. If the spring is to be replaced, remove the 2 screws.
(E) and the spring cassette (F).
A
B
E
F
D
C
1. Loosen the four screws holding the starter to the
crankcase. Lift the starter o the chainsaw. See
gure 1.
2. Remove the air guide plate in the starter housing.
3. Pull out the handle 20-30 cm (A) and take out the
cord from the slot in the starter pulley (B). See
gure 2.
4. Rotate the starter pulley anticlockwise until the
tension on the pulley is released. See gure 2.
Starter